Engine Parts

Temperature Sending Unit (Gauges)

Temperature Sending Unit - Made in the USA 1970 - 72 GS / GSX with Factory Gauges Source - Lectric Limited Note: Most Sending units are there own ground so we do NOT recommend using “Thread Tape” as that can interfere with the Grounding capability. .

$26.00 Add to cart

Thermal Air Intake Vacuum Sensor

This is the Cold Air Sensor that mounts in the Air Cleaner Base Fits 1968 - 1972

$39.00 Add to cart

Thermal Air Intake Vacuum Sensor Retainer

This is the Retainer that houses the Cold Air (Thermal Air Intake) Sensor to the Air Cleaner assembly Fits 1968 - 1972 Note: Sensor also available if needed! (Engine Page) Stage 1 Restoration has the most hardware of any vendor for the 1970 – 1972 GS / GSX & Skylark Models. Don’t see what you need ? Give me a call, we probably have it!

$6.00 Add to cart

Sale!

Throttle Cable (455)

Big Block Throttle Cable Total Length (Tip to Tip) is 21" Housing Length (From Bracket to Firewall) is 10 1/4" Replaces GM Part # 1387262 Fits 1970 - 1972 455 Engines with Factory Intake & Carburetor These also fit the 1968-69 Buick's with a 400 engine as well. (Same GM Part #) 350 Cables are different and not currently reproduced at this time. . . Please Note: When installing this to the Carb Stud make sure it does NOT Stick. It must be able to rotate on the stud!! When these are New they can be a bit sticky. Please lubricate the ball stud on the carburetor and work the cable back and forth to keep it from sticking. . Also Note: IF you're using a different carb and/or intake then you will need to go off of measurements to see if this cable will work. As mentioned earlier it is designed to work with the factory components! .

$38.00 Add to cart

Throttle Cable Bracket (455)

This is a nice reproduction of the factory 400/455 Throttle Cable Bracket Fits 1968 - 1972 Big Blocks

$35.00 Add to cart

Throttle Cable Retainer

This is the Retainer that holds your Throttle Cable to your Gas Pedal Fits 1968 - 1972 (Maybe more) Stage 1 Restoration has the most hardware of any vendor for the 1970 – 1972 GS / GSX & Skylark Models. Don’t see what you need ? Give me a call, we probably have it!

$6.00 Add to cart

Throttle Return Spring

Throttle Return Spring painted in the correct Green that was used by Buick Fits V8 Buick Engines from that era. Note: The diameter of this reproduction spring is a tad smaller than the OEM springs. Works just fine if you don't have an OEM one laying around.

$10.00 Add to cart

Throttle Return Spring Bracket

This is a nice reproduction of the Throttle Return Spring Bracket used on Buick V8 Motors Fits 1967 - 1972 Stage 1 Restoration has the most hardware of any vendor for the 1970 – 1972 GS / GSX & Skylark Models. Don’t see what you need ? Give me a call, we probably have it!

$15.00 Add to cart

Sale!