4 Speed Shift Handle Bracket w/Bolts
4 Speed Shift Handle Bracket with Correct Bolts Fits 1970 - 1972 Muncie 4 Speed Trans  
$45.00 Add to cart
4 Speed Shift Pattern Emblem
This is the 4 Speed Pattern Emblem that mounts on the forward consoles found on some 4 speed cars. Fits 1965 - 1972  
$24.00 Add to cart
4 Speed Shifter Boot (Lower w/Console)
This is the Lower Shift Boot used on 4 Speed Cars WITH a Console. It is mounted below the carpeting as shown in the photo below. The Console then mounts on top of the Carpeting. Fits 1965 - 1972     Photo shows our Shift BootBoot Retainer  and  Retainer Screws.
$39.00 Add to cart
4 Speed Shifter Boot (Lower)
This is the Shift Boot used on cars with NO Console It is the "stand alone" boot used on 4 speed cars that do not have a console surrounding the shifter. Fits 1965 - 1972   .
$56.00 Add to cart
4 Speed Shifter Rod & Tab Set
Hurst Shifter Rod & Tab Set You get the 3 Shift Rods, 3 Piece Tab Set, Metal Bushing & Clip Set Fits 1970 - 1972 with original transmission  (For Muncie Transmissions)    
$229.00 Add to cart
Back Drive Adjustment Fitting
Back Drive Adjustment fitting Fits 1968 - 1972   .
$9.00 Add to cart
Back Drive Bracket for 4 Speed Cars
GM A-Body 4 Speed Back Drive Bracket Fits 1969 - 1972 4 Speed Cars  
$20.00 Add to cart
Back Drive Cross Shaft Hardware
3 Pc Hardware Kit for the Back Drive Cross Shaft to Trans Bracket Fits 1969 - 1972   .
$6.00 Add to cart
Back Drive Cross Shaft Hardware
5 Pc Back Drive / Cross Shaft Hardware kit.  (Spring, Bushing, Washer & Mounting Screws) Fits 1969 - 1972   .
$10.00 Add to cart
Back Drive Rod Hardware
This Kit contains the Bushing, Grommet, Washer & Retaining Pin to connect "Back Drive" Rod to the Steering Column Fits 1969 - 1972   .
$9.00 Add to cart
Ball Stud – 350 Engine (7/8″)
This is the Ball Stud that mounts to your Engine Block for the Z-Bar Assembly Fits 1964 - 1972 Buick 350 Motors.   (Will work on the 455 if you convert to the standard Z-Bar used on the 350 Cars)       .
$10.00 Add to cart
Ball Stud – 455 Engine (1″)
This is the Ball Stud that mounts to your Engine Block for the Z-Bar Assembly Fits Buick 455 Motors.   (This is the Bigger 1" Size Ball Stud that Buick used on there 455 Motors) This must be used with a Factory Z-Bar OR the reproduction model that we offer. Source - High Torque Racing  
$45.00 Add to cart