Transmission / Automatic

Nice reproduction of the woodgrain shift handle used on Floor Shifters Fits 1970 - 72  (Correct for 1970) - Woodgrain Version     If you need the Correct Hardware for your Floor Shifter be sure to check out our Floor Shift Hardware Kit   Note: When installing the screws that hold the handle in place be sure to place some lube on them and install slowly!! (Otherwise you can crack the plastic handle)  

This is the (Shifter Cradle) for the Automatic Floor Shift assembly used by Buick Fits 1970 - 1972 4 pcs total   It is crucial that you use the Proper Phillips Screws when installing the Handle and Pull bar or the shifter will not slide up and down properly! If you need the Correct Hardware for your Floor Shifter be sure to check out our Floor Shift Hardware Kit       Note:  If you're also using the aftermarket Chrome Shifter Handle Insert you will want to drill out the holes shown below to 5/16". We've found that the Chrome Shifter Handle Inserts are a tad to short to properly snap into the shifter cradle. See photos below for more on this!   The Circled area shows the hole that needs to be "enlarged". In most cases you can simply drill this hole out to 5/16". (It's currently a 1/4" hole) The bigger hole allows for the Tabs on the Chrome Insert to lock in place. IF you still have a Factory Handle Insert then you may not need to do this.   If needed you can also take a hand file or dremel tool and enlarge the hole towards the TOP!  This will allow the Chrome Insert to Snap in to place easier.   You're basically enlarging the holes so that the Shifter Insert Tabs will snap in to the Cradle better.